Dongguan caiao Precision Machinery Co., Ltd

News

How should we debug the automatic feeder
Release time: 2020-08-13 11:05:23  Hits: 31

How should we debug the automatic feeder


1. When the automatic feeder starts the punch for continuous stamping, it is necessary to rotate the speed adjusting screw of the feeder in a clockwise direction, and the sliding block moves slightly slowly, so that it can be seen whether the nylon gasket and the length adjusting screw are touched when the slider moves back and forth.




2. During the test run, the slide block moves back and forth. If it only touches the nylon gasket and does not touch the length adjusting screw, this is because the floating rod does not fall deep enough, so the guide screw on the punch should be adjusted down slowly.




3. If the slider moves back and forth, the feeder only touches the length adjusting screw, but does not touch the nylon gasket. This is because the floating rod drops too deep, so the guide screw on the punch should be adjusted slowly.




4. If the slider moves between the length adjusting screw and the nylon gasket and the distance between the two sides is equal, it is necessary to rotate the speed adjusting screw in the counter clockwise direction to make the sliding block speed normal, and make the sliding block meet the nylon gasket and spacer ring when reciprocating.




5. If the press speed is constant and the feeding distance needs to be changed from long to short, first adjust the guide screw to reduce the falling distance of the floating rod, and then rotate the speed adjusting screw clockwise so that the feeding can match the speed of the punch.


Previous: What factors affect the price of ...

Next: Mask machine debugging skills